Agency TRANSPORTATION DEPT

Contractor American Engineering Testing

SWIFT Contract Number B52909

Project Name Data Collection & Validation of MnROAD Strain Gaug

Project Number (if applicable) {Empty}

Summarize purpose of the contract, including why it was necessary: The work performed under this contract validated the equipment settings and procedures used to collect dynamic strain data at MnROAD. This included incorporating any necessary changes to the National Instruments data collection system.

Project Duration

Start Date Thu, 01/27/2011 - 00:00

Original end date Sat, 12/31/2011 - 00:00

Actual end date Thu, 06/30/2011 - 00:00

Did project finish on time? Yes

Total billable hours utilized (if applicable) 303

Contract Amounts

Original contract: $29985.00

Amendments {Empty}

Contract total $29985.00

Did project finish within budget? Yes

What was the funding source? Trunk Highway

Is this a sole source contract? No

If this was a single source contract, explain why the agency determined there was only a single source for the services (if applicable) {Empty}

Evaluator Name Tim Clyne

Evaluator Email Address tim.clyne@state.mn.us

Evaluate the contractor's timeliness Average - report delivered on time

Evaluate the contractor's quality Above average

Evaluate the contractor's cost Average - reasonable for the project

Evaluate the contractor's overall performance AET did a good job on this contract. They delivered on time and on budget, NI Operation Manual (final report) was thorough and descriptive. Hands on training with the software was very helpful for our continuing operations.

Would you engage the contractor's services again? Yes

Describe any negative action taken during the duration of this contract (i.e., termination, pursuit of suspension, etc.): {Empty}

Please rate the overall experience with the contractor 5 - very satisfied