Agency Transportation Department

Contractor WSB & Associates, Inc.

SWIFT Contract Number 195629

Project Name AMG Relative Milling Method – Existing and Milled Relative Surface Model Development

Project Number (if applicable) 1046806

Summarize purpose of the contract, including why it was necessary: To validate a proof of concept (that a relative system can be used with mm accuracy on given applications for profile milling
and/or paving) and to evaluate the scanner and equipment used to generate the 3D model. MnDOT did not have the resources
or equipment to compete project on its own.

Project Duration

Start Date Fri, 06/18/2021 - 00:00

Original end date Thu, 06/30/2022 - 00:00

Actual end date Wed, 11/30/2022 - 00:00

Did project finish on time? Yes

Total billable hours utilized (if applicable) {Empty}

Contract Amounts

Original contract: $99930.12

Amendments {Empty}

Contract total $99930.12

Did project finish within budget? Yes

What was the funding source? state funds

Is this a sole source contract? No

If this was a single source contract, explain why the agency determined there was only a single source for the services (if applicable) {Empty}

Evaluator Name Sindt,Matthew George

Evaluator Email Address Matthew.Sindt@state.mn.us

Evaluate the contractor's timeliness Good

Evaluate the contractor's quality Good

Evaluate the contractor's cost Within expectations

Evaluate the contractor's overall performance Good

Would you engage the contractor's services again? Yes

Describe any negative action taken during the duration of this contract (i.e., termination, pursuit of suspension, etc.): {Empty}

Please rate the overall experience with the contractor 5 - very satisfied